Pro Tools version 9 added the ability to read Extensible Broadcast WAV files that are rigidly defined to be SMPTE ordered. Please see my post I left at the Avid forum about this very topic.The short version is that files read from disk or written to disk are not always in the Film order format as expected.
#Where is my input source on pro tools 12.6 how to#
But as I've just learned yesterday, just when you think you know how to use Pro Tools proficiently nothing is preventing Avid changing the rules without letting everyone know. So even though you are probably going to use the SMPTE order for the main output to your speakers, the audio on the track itself it always in film order.įiled under Post Production Sound, Pro Tools Basics, Sound Theory | 3 Comments | įor quite a number of years, since Pro Tools has had the ability to both read and create multichannel sound files, this explanation was correct. From this one consistent starting-point, you can then route things anywhere you like! Just remember, the audio channels on the 5.1 track itself are in film order from top to bottom: L, C, R, Ls, Rs, LFE. The audio channels on the track itself must be in film order. Pro Tools has to have an absolute somewhere, in order for the I/O page to make sense and function. Lastly, the sixth channel has some unique modulation that is sparse, so this is probably the LFE. The fourth and fifth channels look like a very low-level version of the modulation on the first and third channels, so these must be the surrounds. The second channel shows unique and large modulation not shared anywhere else, and it sure looks like dialog. You can see what looks like music modulation on the first and third channels, so this is likely L and R. Take a look at this 5.1 audio track, and you can tell just by looking at the modulation that this is in fact the order of the audio channels, from top to bottom. Regardless of what kind of crazy output you have your 5.1 audio track going to, the audio on the track itself must be ordered this way: L, C, R, Ls, Rs, LFE. It knows because within the audio track itself, there is a fixed channel order that is used and never changes the “film” standard. So this is all fine and good, but it brings up a very important question: if I can set the output path of my 5.1 audio track to any old random output that I like, how does Pro Tools know which channel goes where? The I/O page identifies the channels as L, R, C, LFE, LS, and RS, but how does Pro Tools know which channel of audio on my track is actually the center channel, or the left, or LFE?
So when switching between 5.1 and stereo, the physical outputs for L and R don’t change. What’s the main benefit of the SMPTE standard over any other? The main advantage is that L and R map to outputs 1 and 2, just like a stereo setup.
However, the most likely output option you’ll use is the SMPTE standard, like this: It gets even messier because Pro Tools lets you route the channels of your 5.1 path to any physical output you want! You could even set up a goofy output like this if you wanted to: These are also just the four preset default options. Life sure would be easier if there were only one channel order! This is due to the fact that there are these different standards in the first place. There is often some confusion regarding the way channels map on a 5.1 audio track in Pro Tools. You can see in parentheses the descriptions of the different channel orders. This lists the common standards for how to arrange the 6 channels of a 5.1 path. Under the Setup Menu, on the “I/O…” setup page, you’ll see an option for default 5.1 path order.
Let’s take a quick look at how we deal with this in Pro Tools. There are several different standards for how we can order those 6 channels. This breaks down into the standard channels of Left, Center, Right, Left Surround, Right Surround, and LFE. Pro Tools supports a variety of surround sound formats, but of course the most common is still 5.1 surround.
0 kommentar(er)
